Equipment Applications
Heat Process Applications
Direct Heating Applications
Heat Inquiry Submittal Forms
Heat Inquiry Submittal Forms
Heat Inquiry Submittal Forms
412-276-3388
Heat Exchange and Transfer home page
Heat Exchange Applications Inquiry
Heat Exchange and Transfer Service
Request Information or a Quote

Heating Tanks - Indirect Heating of Tanks


Indirect heating of tanks by Heat Exchange and Transfer Tube Tracing Heat Exterior Jacket Heat Panel Coil Serpentine Coil Heating

 

Additional Information About Indirect Heating of Tanks

Equipment Inquiry Forms
Have a Question of Heat Exchange Equipment

  • Principles of Operation
  • Applications
  • Critical Data

One of the most accurate and efficient methods of Tank Temperature Control is to circulate a fluid media through a heat transfer coil or jacket. A single fluid can be used to provide both heating and cooling as required to control the temperature of the tank contents. Depending on temperature range, these fluids can be water, glycol mixtures, or heat transfer oils. Circulating heat transfer systems can be equipped with independent heating and cooling capacity or they can be tied into existing plant central heating and cooling utilities. Tanks can be equipped with either internal or external coils in a variety of configurations and installation methods.

Nearly every liquid storage tank can utilize indirect heating and cooling temperature control. Common applications include: large water and oil storage tanks, chemical tank farms, railroad terminals and pipeline terminals. New tanks are typically equipped with serpentine pipe coils or U tube coils. Existing tanks can be equipped with external bolt-on panel jackets or tube tracing.

Properly designing a heat transfer system for tanks requires the following information

  • Jacket or coil detail; the pump must be sized base on design of the flow paths 
  • Detailed drawing of tank is very helpful 
  • The quantity and size of connection ports will help determine maximum flow capacity 
  • The size of the heater is based on the volume of the tank or vessel and the heat-up time required.

Click on the Inquiry Forms link for complete system design information.

 

 
 
Copyright © 2010 Heat Exchange and Transfer, Inc.
  Terms of use / Privacy statement